Sony HT-DDW900 - Manual (Page 7)

7 US
E:\SEM_soowan(film)\J9050000_2662263112DDW900_US\2662263112\US03CON_HT-
DDW900-U.fm masterpage: Right
HT-DDW900
2-662-263-11 (2)
Gettin
g
Sta
rted
About the indicators on the display
MEMORY
L C R
SL S SR
SW
LFE SP A
SP B
STEREO MONO D.RANGE SLEEP OPT COAX
DIGITAL ; DTS ; PRO LOGIC II
q; 9 qf
qg
qs qd
HDMI
qa
2 1 4 3 5 6 7
8
Name Function
A SW Lights up when the audio signal
is output from the SUB
WOOFER jack.
B LFE Lights up when the disc being
played back contains an LFE
(Low Frequency Effect)
channel and the LFE channel
signal is actually being
reproduced.
C SP A/SP B Lights up according to the
speaker system used. However,
these indicators do not light up
if the speaker output is turned
off or if a headphone is
connected.
D ;DIGITAL Lights up when Dolby Digital
signals are input.
Note
When playing a Dolby Digital
format disc, be sure that you
have made digital connections
and that INPUT MODE is not
set to “ANALOG” (page 56).
E ;PRO
LOGIC (II)
Lights up when the receiver
applies Pro Logic processing to
2 channel signals in order to
output the center and surround
channel signals. “; PRO
LOGIC II” lights up when the
Pro Logic II Movie/Music/
Game decoder is activated.
Note
Dolby Pro Logic and Dolby Pro
Logic II decoding do not
function for DTS format
signals.
F DTS Lights up when DTS signals are
input.
Note
When playing a DTS format
disc, be sure that you have made
digital connections and that
INPUT MODE is not set to
“ANALOG” (page 56).
G MEMORY Lights up when a memory
function, such as Preset
Memory (page 54), etc., is
activated.
H Preset
station
indicators
Lights up when using the
receiver to tune in radio stations
you have preset. For details on
presetting radio stations, see
page 54.
I Tuner
indicators
Lights up when using the
receiver to tune in radio stations
(page 52), etc.
J D.RANGE Lights up when dynamic range
compression is activated (page
39).
K HDMI Flashes when you select
“HDMI A.” in the VIDEO
menu (page 58).
L COAX Lights up when INPUT MODE
is set to “AUTO” and the source
signal is a digital signal being
input through the COAXIAL
jack, or when INPUT MODE is
set to “COAX IN” (page 56).
M OPT Lights up when INPUT MODE
is set to “AUTO” and the source
signal is a digital signal being
input through the OPTICAL
jack, or when INPUT MODE is
set to “OPT IN” (page 56).
Name Function
continued
US01COV_HT-DDW900-U.book Page 7 Thursday, December 15, 2005 4:08 PM