Sony IPT-DS2 - Manual (Page 25)

7-GB
Preparing the unit
Inserting batteries
You can use the following batteries.
Two LR6 (size AA) alkaline batteries ˎ
Two AA Nickel-Metal Hydride batteries ˎ
1 Turn this unit off by sliding the ON/OFF
(power) switch to OFF.
2 Open the battery cover.
Note ¦
Be careful not to pull or exert a force on the foot of ˎ
this unit when opening the battery cover. Doing so
can cause a malfunction.
3 Insert the batteries into the battery
compartment according to the marks
inside the compartment.
4 Close the battery cover.
Notes ¦
The batteries inserted in this unit only power this ˎ
unit. They cannot power or charge the camera.
Be careful not to touch the multi connector when ˎ
holding this unit.
You cannot use manganese batteries. ˎ
Always use the same kind of batteries together. ˎ
Check the polarities of the batteries when inserting ˎ
them into this unit. If you insert the batteries in the
wrong direction, this unit does not work.
Do not use a new or charged battery together with ˎ
a dead battery.
To remove batteries
Turn this unit off and then remove the batteries.
Note ¦
When removing the batteries, be careful they do ˎ
not fall and cause injury.
Tip ¼
Remove the batteries if this unit will not be used ˎ
for a long period of time.
Battery level
If the battery level is low, the operation/battery
indicator flashes slowly. If the battery level gets
lower, indicator flashes more rapidly and this unit
automatically enters standby mode.