Troubleshooting – Sony IPT-DS2 User Manual
Page 32
14-GB
Troubleshooting
If any problems occur with your products, refer to the following solutions.
If the problem persists, contact your Sony dealer.
Symptom
Cause/Solution
The operation/battery indicator
flashes rapidly in white.
The camera has no more available memory.
ˎ
Remove the camera from this unit and delete some images.
The lens cover of the camera is closed.
ˎ
Open the lens cover.
The operation/battery indicator
slowly flashes in red.
The batteries are low.
ˎ
Prepare new batteries.
The operation/battery indicator
continues to flash rapidly in red.
The camera is not attached to this unit.
ˎ
Attach the camera to this unit.
Something is caught on the tilt arm, or your hand is pressing against
ˎ
this unit.
The operation/battery indicator
rapidly flashes red and then
goes out.
The batteries inserted in this unit have run out.
ˎ
Replace the batteries. (page 7)
This unit does not work.
The batteries inserted in this unit have run out.
ˎ
Replace the batteries. (page 7)
The battery pack installed in the camera has run out.
ˎ
Install a fully charged battery pack into the camera.
The camera does not turn on.
The camera is not properly attached to this unit.
ˎ
Attach the camera properly to this unit. (page 8)
The camera’s battery level is low.
ˎ
Install charged battery pack in the camera.
The camera cannot be attached
properly to this unit or is
unstable.
The camera is not fixed properly.
ˎ
Attach the camera properly. (page 8)
No images are shot.
The camera is set too far from or too close to the subject.
ˎ
Set the camera within the face detection range of the camera.
If there is only a small change in facial expression or composition,
a shot may not be taken right away even when a face is detected.
The camera is in [Set to on for demo mode].
ˎ
Change the setting of the camera. For details, refer to the user’s
manual of the camera.
This unit stops moving during
use.
If the camera does not detect any faces, this unit may stop operating.
ˎ
Press the MENU (stop) button twice.
The batteries inserted in this unit have run out.
ˎ
Replace the batteries. (page 7)
The camera is not attached properly.
ˎ
Attach the camera correctly. (page 8)