Sony KLV-26HG2 - Manual (Page 13)

13
Installing and Connecting the TV
Connecting a Satellite Receiver
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver’s SATELLITE
IN jack.
2
Using AUDIO and S VIDEO cables, connect the satellite receiver’s AUDIO
and S VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
Tip
• If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
3
Connect the supplied 75-ohm coaxial cable from your cable or antenna to the
TV’s VHF/UHF jack.
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
sure “Auto YC” in the
(Setup) menu is set to “On” to view the S VIDEO input (see page
12).
Tips
• You can also use the VIDEO 2 IN jacks located on the left side of the TV to connect your
satellite receiver.
• Use TV/VIDEO on the remote control to select VIDEO 1 IN (or VIDEO 2 IN if you use the
VIDEO 2 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be turned on).
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
S VIDEO
Rear of TV
75-ohm coaxial
cable (supplied)
S VIDEO cable
(not supplied)
AUDIO cable (not supplied)
Satellite
antenna
cable
Satellite receiver