Sony PCG-R505JSP - Manual (Page 112)

Change text in this variable definition to document title.
112
Troubleshooting the Docking Station
I cannot operate the optical drive in the docking station, when
the docking station is connected to the notebook.
Follow these steps to set the i.LINK network switch.
1 Disconnect your notebook from the docking station.
2 Disconnect the AC adapter and all cables from your docking station.
3 Set the i.LINK® network switch on the bottom of the docking station to the
unmarked side, with a thin pen tip.
4 Connect the docking station to the notebook.
5 Turn on your notebook.
I cannot operate the optical drive in the docking station, when
the docking station is connected to the notebook and the
notebook is connected to another computer via an i.LINK
connection.
Set the i.LINK network switch at the bottom of the docking station to the marked
side. See “If your notebook is connected to the docking station” for more
information.
An error message appears while disconnecting the docking
station, even after following the correct procedure for
disconnecting the docking station.
Close the software in use, disconnect other devices being used, then try to
disconnect the docking station from the notebook.
✍
Do not set the i.LINK network switch when the notebook is on. This causes the
notebook to malfunction.
Set the i.LINK network switch after removing all cables connected to the docking
station.