Sony HDR-TD30V - Manual (Page 236)

To change the battery of the Wireless Remote Commander
While pressing on the tab (A), inset your fingernail into the slit to pull out the battery case.
Place a new battery with the + side facing up.
Insert the battery case back into the Wireless Remote Commander until it clicks.
When the lithium battery becomes weak, the operating distance of the Wireless Remote Commander
may shorten, or the Wireless Remote Commander may not function properly. In this case, replace
the battery with a Sony CR2025 lithium battery. Use of another battery may present a risk of fire or
explosion.
On handling the LCD screen
If you leave fingerprints, hand cream, etc. on the LCD screen, the coating of the LCD screen will
come off easily. Wipe those off as soon as possible.
If you wipe the LCD screen strongly with a tissue, etc., the coating of the LCD screen may be
scratched.
If the LCD screen becomes dirty with fingerprints or dust, it is recommended that you gently remove
those from the screen then clean it with a soft cloth, etc.
LCD screen
Do not exert excessive pressure on the LCD screen, as it may cause uneven color and other
damage.
If your camcorder is used in a cold place, a residual image may appear on the LCD screen. This is
not a malfunction.
While using your camcorder, the back of the LCD screen may heat up. This is not a malfunction.
On handling the casing
If the casing is soiled, clean the camcorder body with a soft cloth lightly moistened with water, and
then wipe the casing with a dry soft cloth.
Avoid the following to avoid damage to the finish:
Using chemicals such as thinner, benzine, alcohol, chemical cloths, repellent, insecticide and
sunscreen
Handling the camcorder with above substances on your hands
Leaving the casing in contact with rubber or vinyl objects for a long period of time
To clean the flash
If fingerprints or dust make the flash dirty, it is recommended that you use a soft cloth to clean it.
About care and storage of the lens
Wipe the surface of the lens clean with a soft cloth in the following instances:
When there are fingerprints on the lens surface
In hot or humid locations
When the lens is exposed to salty air such as at the seaside
It is recommended that you use [Auto 3D Lens Adjust] after wiping the lens.
Store in a well-ventilated location subject to little dirt or dust.
236