Sony DPP-FP97 - Manual (Page 34)

34 GB
4
Adjust an image.
For how to adjust an image, see step 5 on
page 27. When you adjust an image, the
image is added to the image area.
To superimpose a stamp or characters, see
page 28.
5
Press PRINT.
1
From the CreativePrint menu
(page 19), press g/G/f/F to select
(ID Photo), then press ENTER.
The window used for setting the height
and width of an ID photo is displayed.
Tip
You can set a maximum size of 7.0 (width) ×
9.0 (height) cm.
2
Press g/G/f/F to select the item
that you want to adjust, and press
ENTER.
• To specify the unit: Select the text box at
the left of the photo frame. You can select
either “cm” or “inch.”
• To specify the height: Select the figure box
at the right of the photo frame.
• To specify the width: Select the figure box
in the upper of the photo frame.
3
Press f/F to set the size or unit and
then press ENTER.
The layout image of the selected size is
displayed.
4
If you want to specify the other size,
repeat steps 2 and 3.
5
Press g/G/f/F to select and
press ENTER.
The window for selecting an image is
displayed.
6
Press g/G/f/F to select the desired
image, and then press ENTER.
The window used for adjusting the image
is displayed.
You can also set the following adjustment
items.
For other adjustment items, see step 5 on
page 27.
To superimpose a stamp or characters, see
page 28.
7
Press g/G to select and press
ENTER.
8
Press PRINT.
Note
An ID photo print using this printer may not be
acceptable to be used for an identification card or
passport. Please check the requirements for the photo
to be used in the certificate before you submit the card
or passport.
Making an ID Photo
Items Procedures
Adjust the picture quality
of an image. (page 22)
Displays the window to
correct red-eye
phenomenon. (page 24)
Makes an image into
monochrome pictures.
(page 22)