Sony STR-DH500 - Manual (Page 46)

46 US
Enter the frequency of a station directly by
using the numeric buttons.
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Press D.TUNING.
3
Press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1
b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1
b 3 b 5 b 0
If you have tuned in an AM station, adjust
the direction of the AM loop antenna
(aerial) for optimum reception.
4
Press ENTER.
You can also use MEMORY/ENTER on
the receiver.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
(Models of area code U, CA only)
You can change the AM tuning scale to either
9 kHz or 10 kHz using the buttons on the
receiver.
1
Press ?/1 to turn off the
receiver.
2
While holding down TUNING
MODE, press ?/1.
3
Change the current AM tuning
scale to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
Note
All preset stations will be erased when you change
the tuning scale.
Tuning into a station directly
(Direct Tuning) Changing the AM tuning scale
?/1
PHONES
INPUT SELECTOR
INPUT MODE TUNING MODE
MASTER VOLUME
DISPLAY DIMMER MUTING MEMORY/ ENTER 2CH/ A.DIRECT A.F.D. MOVIE MUSIC TUNING
?/1
TUNING MODE