Sony BDV-N8100W - Manual (Page 73)

73 US
BDV-N9100W/BDV-N8100W/BDV-N7100W
4-456-334-12(1)
D:\NORM'S JOB\SONY HA\SO130019\BDV-N9100W (PMRF
01)\4456334121_US (U)\100ADD.fm masterpage: Right
A
d
d
ition
al In
form
atio
n
• Turns off.
– Check that the AC power cord
(mains lead) of the surround
amplifier is connected securely.
– Turn the surround amplifier on by
pressing "/1 on the surround
amplifier.
• Flashes green quickly.
– 1 Press "/1 on the surround
amplifier.
2
Insert the wireless transceiver
into the surround amplifier
correctly.
3
Press "/1 on the surround
amplifier.
• Flashes red.
– Press "/1 to turn off the surround
amplifier, and check the following
items.
1 Are the + and – speaker cords
short-circuited?
2 Is anything blocking the
ventilation holes of the
surround amplifier?
After checking the above items and
fixing any problems, turn on the
surround amplifier. If the cause of
the problem cannot be found even
after checking all the above items,
consult your nearest Sony dealer.
• Flashes green or orange slowly or
turns red.
– Make sure that the wireless
transceiver is inserted correctly
into the main unit.
– Make the [Secure Link] setting
again (page 57).
– Sound transmission is poor. Move
the surround amplifier so that the
LINK/STANDBY indicator turns
green or orange.
– Move the system away from other
wireless devices.
– Avoid using any other wireless
devices.
• Turns green or orange.
– Check the speaker connections and
settings.
Noise is heard from surround
speakers or sound from the surround
speakers skips.
t Wireless transmission is unstable.
Change the [RF Channel] setting in
[Wireless Sound Connection]
(page 58).
t Install the main unit and surround
amplifier closer to each other.
t Do not install the main unit and
surround amplifier in a closed rack, on
a metal rack, or under a table.
Radio stations cannot be tuned in.
t Check that the antenna (aerial) is
connected securely. Adjust the antenna
(aerial) or connect an external antenna
(aerial) if necessary.
t The signal strength of the stations is
too weak (when tuning in with
automatic tuning). Use manual tuning.
The disc does not play.
t The region code on the BD/DVD does
not match the system.
t Moisture has condensed inside the
main unit and may cause damage to the
lenses. Remove the disc and leave the
main unit turned on for about half an
hour.
t The system cannot play a recorded disc
that is not correctly finalized
(page 76).
Tuner
Playback