Sony BDV-N8100W - Manual (Page 75)

75 US
BDV-N9100W/BDV-N8100W/BDV-N7100W
4-456-334-12(1)
D:\NORM'S JOB\SONY HA\SO130019\BDV-N9100W (PMRF
01)\4456334121_US (U)\100ADD.fm masterpage: Right
A
d
d
ition
al In
form
atio
n
The [Control for HDMI] function does
not work (“BRAVIA” Sync).
t Check that [Control for HDMI] is set
to [On] (page 64).
t If you change the HDMI connection,
turn the system off and on again.
t If power failure occurs, set [Control
for HDMI] to [Off], then set [Control
for HDMI] to [On] (page 64).
t Check the following and refer to the
operating instructions supplied with
the equipment.
• The connected equipment is
compatible with the [Control for
HDMI] function.
• The connected equipment’s setting
for the [Control for HDMI] function
is correct.
The system cannot connect to the
network.
t Check the network connection
(page 27) and the network settings
(page 65).
You cannot connect your PC to the
Internet after [Wi-Fi Protected Setup
(WPS)] is performed.
t The wireless settings of the router may
change automatically if you use the
Wi-Fi Protected Setup function before
adjusting the settings of the router. In
this case, change the wireless settings
of your PC accordingly.
The system cannot connect to the
network or the network connection is
unstable.
t Check if the wireless LAN router is on.
t Check the network connection
(page 27) and the network settings
(page 65).
t Depending on the usage environment,
including the wall material, radio wave
reception conditions, or obstacles
between the system and the wireless
LAN router, the possible
communication distance may be
shortened. Move the system and the
wireless LAN router closer to each
other.
t Devices that use a 2.4 GHz frequency
band, such as a microwave, Bluetooth,
or digital cordless device, may
interrupt communication. Move the
main unit away from such devices, or
turn off such devices.
t The wireless LAN connection may be
unstable depending on the usage
environment, especially while using
the Bluetooth function of the system.
In this case, adjust the usage
environment.
The wireless router you want is not
shown in the wireless network list.
t Press RETURN to return to the
previous screen, and try [Wireless
Setup(built-in)] again. If the wireless
router you want is still not detected,
select [Add a new address.] from the
network list, then select [Manual
Registration] to input a network name
(SSID) manually.
“BRAVIA” Sync
([Control for HDMI])
Network connection
Wireless LAN
connection