Sony NW-S705FBLACK - Manual (Page 98)

NW-S603/S605/S703F/S705F/S706F.GB 2-887-743-13(1)
 
Troubleshooting...
Messages
Message Meaning Remedy
UPDATE ERROR
The player fails to update
the firmware.
Follow the on-screen
instructions on the
computer and update
again.
USB CONNECT
The player is connected to
a computer.
This is not a malfunction.
You can operate the player
using SonicStage, but you
cannot operate the
controls on the player.
USE ORIGINAL HEADPHONE
(NW-S703F/S705F/S706F only)
The following functions
were used when the
headphones
corresponding to the
Noise Canceling function
were not connected.
 Noise Canceling (
page 28)
 Noise Cancel Control
setting ( page 38)
Connect the supplied
headphones or headphones
corresponding to the Noise
Canceling functions.
To delete abnormal data from the built-in flash memory
If “CANNOT PLAY,” “DRM ERROR,” “EXPIRED,” “FILE ERROR,” “FORMAT
ERROR,” “MEMORY ERROR,” or “NO DATABASE” appears, there is a problem
with all or part of the data stored in the built-in flash memory.
Please follow the procedure below to erase data you cannot play.
1
Connect the player to the computer, and start SonicStage.
2
If you have already specified the data with problems, erase the data
using SonicStage.
3
If the problem persists, transfer all data without problems back to the
computer using SonicStage while the player is connected to the
computer.
4
Disconnect the player from the computer and then format the built-in
flash memory using the “Format” menu ( page 57).
Table of
Cont
ents
Inde
x
Menu