Sony RCD-W3 - Manual (Page 11)

11
Basic Operations
Locating a Particular
Point in a Track
You can also use the m and M buttons to
locate a particular point in a track during
playback or playback pause.
Before using the remote, set SELECT to CD
for operations on DECK A, or to CDR for
operations on DECK B.
To locate a
point
While
monitoring the
sound
Notes
• If the disc reaches the end while you are pressing
M on the remote during sound monitoring, the
recorder stops.
• Tracks that are only a few seconds long may be too
short to scan using the search function. For such
tracks, it is better to play the disc at normal speed.
Press and hold
During playback, press m or M
on the remote repeatedly.
Playing Tracks
Repeatedly (Repeat Play)
You can play tracks repeatedly in any play
mode.
Before using the remote, set SELECT to CD
for operations on DECK A, or to CDR for
operations on DECK B.
1
Each time you press REPEAT on the
remote, the REPEAT indicator in the
front panel display lights and toggles
as “REPEAT,” “REPEAT 1,” and then
lights off.
The deck repeats the tracks as follows:
When the disc
is played in
Normal play
(page 7)
Shuffle play
(page 12)
Program Play
(page 12)
2
Press H .
To stop Repeat Play
Press x.
To cancel Repeat Play
Press REPEAT until the indicator disappears.
Note
You cannot use Repeat Play, when Relay Play is ON
(page 13).
The deck repeats
All the tracks by “REPEAT”.
One track repeat by “REPEAT 1”
All the tracks in random order by
“REPEAT”
All the same Program by
“REPEAT”
REPEAT
m / M