Sony RCD-W3 - Manual (Page 13)

13
Basic Operations
To erase the last programmed track
Press CLEAR on the remote. Each time you
press the button, the last programmed track is
erased.
Tip
The program remains even after Program Play ends.
When you press H, you can play the same program
again.
Notes
• “Full” appears on the front panel display when you
program over 20 tracks. Erase the unnecessary
tracks to enter other tracks.
• The program is erased when you press POWER to
turn off.
Alternating Discs from One
Tray to the Other (Relay
Play)
When there is a disc in each deck, you can
alternately play the decks so that when one disc
is finished, the other will begin to play
automatically for continuous play between the
2 decks.
Before using the remote, set SELECT to CD
for operations on DECK A, or to CDR for
operations on DECK B.
Press RELAY until “RELAY” appears in the
display.
When the disc in DECK A has played through
to the end, DECK B begins to play. Play
alternates between the two decks continuously
until you press stop or change operations.
To stop Relay Play
Press x.
Note
“REPEAT” or “REPEAT 1” is canceled if you set
Relay Play.
RELAY
RELAY