Sony KLV-21SR2 - Manual (Page 12)

12
Installing and Connecting the TV
Connecting a VCR and Cable TV
Use this hookup if:
• You have cable TV that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the VCR’s IN jack.
2
Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack
to the TV’s VHF/UHF jack.
3
Using AUDIO and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
Note
To watch the pictures input from the S VIDEO input jack, set “Auto YC” to “On” in the
(Setup) menu (See below).
Tips
• You can also use the VIDEO 2 IN jacks to connect your VCR.
• If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
When connecting both VIDEO OUT and S VIDEO OUT
You can select the jack the TV receives the input signal from on the menu screen.
The TV is factory set to receive S VIDEO input signals.
1 Press TV/VIDEO repeatedly to select VIDEO 1 IN.
2 Press MENU.
3 Press V/v to select (Setup), then press .
4 Press V/v to select “Auto YC,” then press .
5 To watch the pictures input from the S VIDEO input jack:
Press
V/v to select “On,” then press .
To watch the pictures input from the VIDEO input jack:
Press
V/v to select “Off,” then press .
6 Press MENU to exit the menu screen.
Rear of TV
S VIDEO cable
(not supplied)
AUDIO cable
(not supplied)
VCR
Cable
S VIDEO
75-ohm coaxial
cable (supplied) 75-ohm coaxial
cable (supplied)
AUDIO-R (red)
VIDEO (yellow)
AUDIO-L (white)