Sony SDM-N50PS - Manual (Page 10)

10
Installing the display vertically
This display can be installed either horizontally or vertically using
the supplied display stand.
To switch to the horizontal or vertical viewing
position
First install the supplied WinPortrait (for Windws 95/98 and
NT4.0) or MacPortrait (for Macintosh). To switch the view, press
Shift + Ctrl + R on the keyboard. For more information, see the
supplied software’s instruction manual.
To install the display horizontally or vertically
Open the display stand until the click sound is heard.
Put the display on the stand, aligning the mark which shows the
stand position on the display.
To close the display stand
While sliding the stopper up, close the display stand.
Using the headphones
You can listen to the audio signals from your computer or other
audio equipment using headphones.
Connect the AUDIO IN jack to the audio output jack of your
computer or other audio equipment using the supplied audio cord.
Adjusting the volume
1 Press the 2 +/– buttons.
The VOLUME menu appears on the screen.
2 Press the 2 +/– button to adjust the volume.
The menu automatically disappears after about 3 seconds.
Notes
• You cannot adjust the volume when displaying the main menu on the
screen.
• When your monitor is in power saving mode, no sound comes from the
headphones.
Vertical installation
Horizontal installation
The stand positioning mark
The stand positioning mark
The stopper
VOL UME
4 0
,