Specifications, Main unit – Sony LBT-LCD7Di User Manual

Page 126

Advertising
background image

MHC-GZR33Di/LBT-LCD7Di.GB.4-143-233-12(1)

1

GB

On heat buildup

 Heat buildup on the unit during operation is

normal and is not cause for alarm.

 Do not touch the cabinet if it has been used

continuously at a high volume because the

cabinet may have become hot.

 Do not obstruct the ventilation holes.

In case color irregularity is observed

on a nearby TV screen

With the magnetically shielded type of

speakers, the speakers can be installed near a

TV set. However, color irregularity may still

be observed on the TV screen depending on

the type of your TV set. In this situation, turn

off the TV, wait 15 to 30 minutes, and turn it

back on. If there is no improvement, move the

speakers far away from the TV.

IMPORTANT NOTICE

Caution: If you leave a still video image

or on-screen display image displayed on

your TV for an extended period of time via

this system, you risk permanent damage

to your TV screen. Projection TVs are

especially susceptible to this.

Cleaning the cabinet

Clean this system with a soft cloth slightly

moistened with a mild detergent solution.

Do not use any type of abrasive pad, scouring

powder, or solvent, such as thinner, benzine,

or alcohol.

Specifications

Main unit

AUDIO POWER SPECIFICATIONS

POWER OUTPUT AND TOTAL

HARMONIC DISTORTION:

(LBT-LCD7Di The United States model

only)

With 6 ohm loads, both channels driven,

from 120  10,000 Hz; rated 85 watts per

channel minimum RMS power, with no

more than 1% total harmonic distortion

from 800 milliwatts to rated output.

Amplifier section

The following measured at AC 120 V, 60 Hz

(North American model)

The following measured at AC 230 V,

50/60 Hz (European model)

The following measured at AC 240 V,

50/60 Hz (Australian model)

MHC-GZRDi

Power output (rated):

105 W + 105 W (at 6 Ω, 1 kHz, 1%

THD)

RMS output power (reference):

180 W + 180 W (per channel at 6 Ω,

1 kHz, 10% THD)

LBT-LCD7Di

Power output (rated):

105 W + 105 W (at 6 Ω, 1 kHz, 1%

THD)

RMS output power (reference):

180 W + 180 W (per channel at 6 Ω,

1 kHz, 10% THD)

Advertising