Anschutz 9003 - Manual (Page 16)

30
back and forth in the barrel.
• Then pull cleaning cords in dry condition
through the barres until the last one shows
no considerable dirt.
• After cleaning or before shooting the next
time fire 10 to 20 shots to get back to the
former shooting performance (oil shots).
• Clean external parts with a slightly oiled
cloth.
Maintenance of the trigger
• Lubricate the bearings slightly with cold
resistant molybdenum disulphide grease
(no salad or cooking oil!) once a year.
• Spot a small amount of oil into the bearing
parts using a needle.
• The internal parts should not be washed
with spray or oil to avoid resin or other
residues in the trigger.
Attention
When cleaning the rifle no dirt, residues of
solvents, grease or non-suitable oils must get
into the trigger mechanism. We therefore
recommend either to clean your gun in a way
that it is horizontal or even with the stock up
to avoid any contamination of the valve unit
and trigger mechanism.
Protect your rifle against dust, sand, humidity,
heat and other harmful influences. Vacuum
clean your gun case or soft gun case once
a month to remove dust and lint. Gun cases
and soft gun cases should have a smooth
and dust rejecting inner lining.
Be aware that condensed water might occur
as a result of temperature variations. In such
a case it has to be removed at once. Only
use gun and soft cases for transport purposes.
Do not store your rifle there. Do not use
containers which might attract humidity to store
your sports device.
Be aware of other possible changes or
damage. In such a case take your rifle to an
authorized gunsmith for checking or send it
to our factory.
To reduce the risk of damage in transit
we recommend the disassembly of the
barreled action from the stock.
When you use your rifle frequently we
recommend having the seals and the piston
checked once a year.
Accessories
Please ask for our catalog or take a look at
our websites under www.anschuetz-sport.com
or www.anschutz-sporters.com. You will find
the latest information there and have the
possibility to subscribe to our free-of-charge
newsletter.
Special accessories
Additional weights
The air rifle can be adapted to your individual
requirements among others in four easy ways:
1. Barrel weights:
By pushing, adding or removing the additio-
nal weight.
2. Counter weight carriers:
They can be installed at the butt plate and
cheek piece. Weight rings can be added to
the counter weight carriers.
3. Weight rings:
By adding them to the columns of the cheek
piece and butt plate adjustment (Order No.
711.3805).
Warranty
A warranty of 2 years will be issued. Parts
which are subjected to wear are not part of
this warranty. In the case of warranty we
substitute the defective parts free of charge.
Cases of warranty will only be accepted if
the article in question and the corresponding
purchase receipt plus filled-in warranty card
are presented. Warranty will not be accepted
if changes or repair works have been carried
out by persons who are not authorized, if the
ANSCHÜTZ product is not used correctly, if
unlawful modifications or manipulations have
been carried out, if any knotting has been
damaged or if non-ANSCHÜTZ original
parts were used. Additional components must
only be used if they have been checked by
4. Heavy steel columns:
Approx. 100 g. For cheek piece adjustment
(Order No. 700.6337). For butt plate
adjustment (Order No. 700.6338).
Stickers
Your rifle is delivered with a sheet of various
stickers which can be attached to the barreled
action carrier as desired.