Anschutz 9003 - Manual (Page 8)

22
• Unscrew both screws at No. 1.
• Loosen threaded pins on both sides
(approx. 4 turns) at No. 2.
• Pull the support block No. 3 off the
barreled action carrier in the direction of
the muzzle.
• Remove barreled action No. 4 from the
barreled action carrier (5).
• Fixing at aluminum barreled action carrier:
Insert/change round (C) Sof t-Link ®
elements (hard or soft) on both sides.
• Fixing at the support block Insert/change
long (A) Soft-Link® elements (hard or soft)
on both sides (2 pieces).
•Assemble again in reversed sequence.
In addition the integrated Soft-Link ® shock
absorber pads are responsible for a tension
free connection of the barreled action and
the barreled action carrier. Vibrations
occuring in the barreled action during shot
release are thus effectively absorbed and no
longer perceptible by the shooter.
The air rifle is equipped with a hard Soft-Link ®
shock absorber pad. An additional soft Soft-
Link
® shock absorber pad is added as an
accessory as well. To change the shock
absorber pads procede as follows:
5 4 1 2 3
A
B
B
C
C A
Soft-Link ®
The barreled action and the barreled action
carrier are connected via the unique and
patent pending Soft-Link
® connecting
system. This new fixing system consists of a
vibration damping fix bearing (in the area of
the housing of the barreled action) and a
vibration damping flexible bearing (in the
area of the support block). Tensions which
occur due to the different materials of barreled
action and barreled action carrier and their
various temperature longitudinal expansion
coefficients are eliminated this way (tension
compensating heat expansion joint).
The technology of the 9003 Premium
7 patents and patent pending
• Tension and vibration free connection (no
direct connection) of barreled action and
carrier through Soft-Link
® shockabsorbers.
Patent pending.
• Absolutely maintenance-free stabilizer.
Patented.
• Ultra short locktime due to new firing pin
(patent pending), optimized with regard
to mass and inertia and completely new
mechanic trigger.
• New and innovative safety concept for the
loading process. The rifle is cocked just
an instant before shooting. Patent pending.
• Dry firing device with active safety.
• Adjustable forend stock (height, length,
tiltable). Patent pending.
• Complete PRO grip equipment (Synthetic,
anti-allergic technical plastic material. Can
be shaped like wood).
• Patented butt plate and cheek piece ad-
justment.
• Patented air filter against pollution.
• Various decorations for barreled action
carrier.
Note
When inserting the soft Soft-Link® elements
the sleeves (B) must be installed at pos. 1 in
the Soft-Link® bearings before assembly.
Subsequently mount the screws at pos. 1 on
both sides and tighten them.
Before first use
• Wipe away excess surface oil.
• Pull a cleaning patch through the barrel
starting from the chamber towards the
muzzle.
Check the tight fit of the screws before every
shooting.