Sony KLV-40ZX1M - Manual (Page 6)

6 US
3 Align the F mark, then press the LCD
monitor against the neck of the Table-Top
Stand and gently slide the LCD monitor onto
the neck. Be sure to work with two or more
people.
4 Attach the LCD monitor to the Table-Top
Stand using the supplied screws. Attach the
two bottom screws first, then the top two
screws.
~
• If an electric screwdriver is used, set the torque to
tighten at approximately 1.5 N·m {15 kgf·cm}.
• Do not put stress on the LCD panel or the frame
around the screen.
If the LCD monitor is to be wall-mounted of
installed on the Floor Stand (optional), remove the
Table-Top Stand.
1
Place the LCD monitor face down.
Lay a mat (packing sheet, etc.) on a table
wider than the LCD monitor, then place the
LCD monitor on the table with the stand
hanging over the edge of the table. Be sure to
work with two or more people.
2
Remove the four screws from the Table-Top
Stand.
~
• Do not use the screws removed from the Table-Top
Stand for the Wall-Mount Bracket or Floor Stand.
• When you carry the LCD monitor, move the monitor
with a mat laid below.
• Hold the Table-Top Stand firmly with both hands.
F mark
1 Bottom screws
2 Top screws
Removing the Table-Top Stand
Packing sheet, etc.