Panasonic CSE18MKEW - Manual (Page 9)

ENGLISH
9
INDOOR UNIT
CAUTION
• Switch off the power supply and unplug before cleaning.
• Do not touch the aluminium fi n, sharp parts may cause injury.
CLEANING INSTRUCTIONS CLEANING INSTRUCTIONS HINT HINT
• Do not use benzene, thinner or scouring powder.
• Use only soap ( pH7) or neutral household detergent.
• Do not use water hotter than 40°C.
• To ensure optimal performance of the unit, cleaning
maintenance has to be carried out at regular intervals.
Dirty unit may cause malfunction and you may see error
code “H99”. Please consult authorized dealer.
1 INDOOR UNIT
• Wipe the unit gently with a soft, dry cloth.
2 FRONT PANEL
Remove Front Panel
• Raise and pull to remove the front panel.
• Wash gently and dry.
Close Front Panel
• Press down both ends of the front panel to close it
securely.
3 REMOTE CONTROL RECEIVER
4 ALUMINIUM FIN
5 HUMAN ACTIVITY SENSOR
6 HORIZONTAL AIRFLOW DIRECTION LOUVER
• Do not adjust by hand.
7 VERTICAL AIRFLOW DIRECTION LOUVER
• Do not adjust by hand.
8 AUTO OFF/ON BUTTON
• Use when remote control is misplaced or a malfunction
occurs.
Action Mode
Press once. Auto
Press and hold until 1 beep is heard,
then release.
Cooling
Press and hold until 1 beep is heard,
then release.
Press again until 2 beeps, then release.
Heating
Press the button to turn off.
9 e-ion CHARGING WIRE
10 e-ion FILTERS
• Clean the fi lters regularly.
• Wash/rinse the fi lters gently with water to avoid damage
to the fi lter surface.
• Dry the fi lters thoroughly under the shade, away from
fi re or direct sunlight.
• Replace any damaged fi lters.
11 ACTIVE e-ion GENERATOR
Clean with dry cotton bud.
• Active e-ion generator cleaning is
recommended every 6 months.
2
3
7
8
1
4
9
10
11
9 , 10 , 11
e-ion AIR PURIFYING
SYSTEM
• Do not touch during operation.
5 HUMAN ACTIVITY SENSOR
• Do not hit or violently press the sensor or
poke it with a sharp object. This can lead to
damage and malfunction.
• Do not place large objects near the sensor
and keep away heating units or humidifi ers
from the sensor’s detection area. This may
lead to sensor malfunction.
5
6