Panasonic TYST05S - Manual (Page 4)

4
English
Installation procedure
This ceiling unit weighs approx. 19kg (41.9lbs).
The display weights approx. 33kg (72.8lbs) to
45kg (99.2lbs). Refer to the diagram on the right
and confirm that the four points for mounting the
ceiling unit and display are capable of bearing
this weight. If the installation location is not
strong enough to bear this weight, reinforce the
ceiling before the ceiling unit and display are
installed.
300 (11 26 / 32 )
300 (11
26
/ 32
)
350 (13 25 / 32 )
Ceiling installation holes
Front
24 (
15
/ 16
)
14 ( 35 / 64 )
R7
(R
9 / 32
)
• Reinforce the ceiling if it is not strong enough.
• Use bolts appropriate for the ceiling material (not supplied).
• Refer to the installing examples for wooden structure and concrete structure.
N o t e
Note
3. Install the ceiling unit
(upper section).
Flat washer
(not supplied)
Spring washer
(not supplied)
M12 bolt
(not supplied)
Earthed mains extension lead
(example)
Signal cable
(example)
1. Before installing the upper section, pull
the wiring through the pipe. Use an
earthed mains extension lead (not
supplied).
2. Make holes in the ceiling using a
method appropriate for the ceiling
structure and for inserting M12mm
bolts. Install the upper section using a
hex socket bolt (M12 not supplied), flat
washer and spring washer.
1. Check the strength of the installation location.
2. Prepare the ceiling unit.
Ceiling unit
(upper section)
M8 assembly screw
Ceiling unit
(lower section)
• Remove the two M8 assembly screws
from the ceiling unit and separate the
upper and lower sections of the unit.
Units : mm (in.)
M12 bolt
Spring washer
Flat washer
curled plug(M12)
Anchor nut or
Concrete
Installing to a concrete structure(example) Installing to a wooden structure(example)
M12 bolt
Spring washer
Flat washer
Flat washer
Nut
Beam
" ] ) (min.thickness 40mm [1 9 /
16
Mounting plate
Ceiling board
Nail