Panasonic TYST05S - Manual (Page 7)

7
English
Removing the display
10. Gather the cables.
Cable
Cable tie
Cable tie
Cable
This ceiling unit can be placed in 7 angles from 0°
to 30° in 5° increments. The factory setting is 0°.
If you wish to change the angle, remove the angle
adjustment screws from the connecting pipe and
adjust the angle adjustment holes to the desired
position. Then reinsert the screws.
9. Adjust the ceiling unit's angle.
Connecting pipe
Angle
adjustment
hole positions
0 ° (vertical)
5 °
10 °
15 °
20 °
25 °
30 °
1. Remove the two fixing screws (M5) at
the left and right sides of the ceiling
unit.
2. Lift the lower part of the display,
pull outward
and lift upward.
②
①
③
Insulating
spacer
Fixing screw (M5)
• Gather the cables connected to the
terminals on the back of the display and
fix in place with a cable tie.
• When removing the display, first return the ceiling
unit angle to 0°.
Caution
Matsushita Electric Industrial Co., Ltd
Central P.O. Box 288, Osaka 530-8692, Japan
Printed in Japan
MS0600Y1