Panasonic TYST05S - Manual (Page 6)

6
English
②
②
Insulating spacer
Notch
Notch
①
①
6. Mount the display in the ceiling unit.
1. Hook the display’s top insulating
spacers in the ceiling unit by aligning
the display with the notches in the
ceiling unit and sliding the display
downward.
2. Insert the bottom insulating spacers by
lifting the display slightly, fitting the
bottom spacers into the holes, and then
lowering the display.
• When mounting the display in the ceiling unit, be
sure the ceiling unit is straight and not at an angle.
Note
• Do not lift the display too high. It may come unhooked from the unit.
Caution
7. Fix the display.
Fixing screw (M5) 1 each
left and right sides
• Install two fixing screws (M5, included)
in the corresponding holes on the ceiling
unit (left and right).
8. Adjust the ceiling unit's direction.
M8 bolt
（ M8-20 ）
• Adjust the angle of the display and fix in
place with two fixing bolts (M8-20,
included).
• Install the fixing screws on the left and right to prevent the display from sliding out of the ceiling unit.
Note
Installation procedure