Salton, Inc AC1875PROHD - Manual (Page 7)

DRYER HOLSTER WALL
MOUNT INSTALLATION
The Dryer Holster is an
excellent way to store your Hair
Dryer while not in use. Please
note that mounting the Holster
is an optional accessory,
therefore you may use and store
your Hair Dryer as you would
any other hair dryer.
CAUTION: Do not mount the
Holster where the Hair
Dryer or cord can fall or be
pulled into a tub or sink.
It is best to mount the Holster
close to an AC electrical outlet,
allowing 3 inches distance
between the outlet and Holster.
There should also be enough
space around the Holster to
allow the Hair Dryer to be
inserted. The surface should be
flat and level.
TOOLS NEEDED: Drill, 1/4" drill
bit, hammer, pencil, Phillips
screwdriver and the
following included items:
3 Screws, 3 Anchors, and
1 Mounting Template.
1. Hold the Mounting Template
flat and level against the wall
where you would like to
mount the Holster. Using a
pencil, follow the template
and draw 3 circles on the wall
where the screws will be
placed. (See Figure 1.)
2. Using the drill and 1/4" drill
bit, drill 3 holes where you
marked them on the wall.
3. Tap the anchors into each of
the 3 drilled holes. Do not tap
the anchors flat against the
wall so that you have a small
part of the anchor exposed.
This will make it easier to
work with when inserting the
screws.
4. Insert the screws into the
anchors by screwing them in
with a Phillips screwdriver.
IMPORTANT:
Leave 1/16"
space be-
tween the
anchor and
the screw so
the threads
are exposed.
This will be
enough space
for the Holster to hang on to.
5. Locate the 3 holes on the
back of the Holster and align
with the 3 screw heads. Press
the Holster flat against the
wall and slide down to secure
in place.
Figure 1
6
Align 3 Holes with
3 Screw Heads
AC1875PROHD_IB_13-2-03 2/13/03 12:35 PM Page 7