Panasonic CZRWSU2 - Manual (Page 13)

6. Timer Operation
EN-9
EN
• When setting the timer, make sure the current time on the remote control is accurate.
• The timer’s clock can only be set when the display of the remote control is ON.
• After setting the timer, put the remote control in a place where its signal will reach the receiver of the
indoor unit. (When the time set for the timer is reached, a signal is sent from the remote control to
Start/Stop the unit.)
Using the Timer
1. Press either / of the or , and while the time is
being displayed, if you press / again, a scheduled time can
be set.
The time last set on the timer is displayed.
“--:--“ indicates time to change the batteries.
2. Press either / of the or and set the timer to the
desired time.
Every time you press / , the time changes in 10 minute increments.
If you press and hold the button, the time changes quickly.
3. After setting the timer, if you press , the time you set
changes to a steady display, indicating settings are complete.
After the timer setting is displayed for three seconds, the display reverts to
the current time.
1, 2 3
Instruction_honbun_all.indb EN-9 Instruction_honbun_all.indb EN-9 2011/04/18 17:54:35 2011/04/18 17:54:35