Panasonic CZRWSU2 User Manual
Page 20
EN-16
Setting Addresses (CZ-RWSY2/CZ-RWSK2)
(Setting the address of the indoor unit)
1. First of all, set the address for the remote control with Setting Remote Control Address
(See Page EN-14).
2. Press [Emergency Operation]
of the indoor unit for four seconds or more.
When you do this, the lamps of the display will blink one after another.
3. Press
on the remote control.
4. The buzzer will sound and the address of the indoor unit will change to the address
displayed on the remote control.
5. If you press [Emergency Operation]
of the indoor unit once, the lamps on the indoor
unit’s display will turn off.
Note
• Please do not hold the [Emergency Operation]
button of the indoor unit down while the indoor unit’s
display lamps are blinking one after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
11. Addresses (Cont.)
Instruction_honbun_all.indb EN-16
Instruction_honbun_all.indb EN-16
2011/04/18 17:54:37
2011/04/18 17:54:37