Panasonic CZRWSU2 - Manual (Page 15)

7. Adjusting the Wind Direction
EN-11
EN
Please face the fl ap (up-down wind
direction plate) downwards. If it faces
upwards, the warm air will not reach
the fl oor level.
In the Heat Mode
Please face the fl ap (up-down wind
direction plate) upwards. If the plate
faces downwards, condensation
may form and drip from around the
air outlet.

In the Cool and Dry Modes
In the Fan Mode In All Modes
Displays with Swing Stopped
Initial Setting
Initial Setting
Initial Setting Moves Constantly
Fan/Heat Modes Cool/Dry Modes
• Never try to manually move the fl ap (up-down wind direction plate) that is operated by the remote
control.
• When the unit stops, the fl ap (up-down wind direction plate) automatically faces downwards.
• When the unit is in heating standby, the fl ap (up-down wind direction plate) faces upward. Also,
bear in mind that the fl ap starts swinging after the heating standby mode is released, but the
display on the remote control indicates Auto Flap during standby heating as well.
CZ-RWSU2/CZ-RWST2/CZ-RWSL2/CZ-RWSY2/
Indoor Unit (CZ-RWSK2)
Setting the Wind Direction
While the unit is operating, every time you press , the
direction the fl ap faces changes.
Setting Flap to Swing
If you press to set the fl ap (up-down wind direction
plate) in its most downward facing position, and then
press
again, is displayed and the fl ap swings
automatically up and down.
Stopping Flap Swing
If you press again while the fl ap is swinging, you can
stop the fl ap from swinging and set it in place as desired.
Thereafter, if you press
, you can set the wind direction
starting from the most upward position.
• When the unit is in the Cool or Dry modes, the fl ap cannot
stop facing downwards. If you try to stop the fl ap from
swinging while it is facing downwards, it will continue
moving until it is in the third position from the top.
Instruction_honbun_all.indb EN-11 Instruction_honbun_all.indb EN-11 2011/04/18 17:54:35 2011/04/18 17:54:35