Panasonic ER5209 - Manual (Page 3)

English
3
Charging
Char
ge
1. Set the switch
to “0•charge”,
and insert the
power cord into
the clipper.
2. Connect the AC
adaptor into an
outlet. The
charging
indicator lamp
will light up.
3. Disconnect the
AC adaptor
from an outlet
when charging
is completed.
• The charging time is 8 hours.
• 1 full charge will provide approximately 40 minutes of continuous
operation.
Inserting the attachment
1 20/30/40mm, 50/60/70mm comb attachments
1. Adjust the attachment to the desired
trimming height by sliding it until it
clicks while the switch is in “0•charge”.
• Set the attachment to the correct position.
Otherwise you cannot set the switch to “1”.
• Actual hair length will be a little longer than
the height you set.
1 3/6mm, 9/12mm, 15/18mm comb attachments
3 mm 6
6mm
3mm 9mm
12mm
18mm
15mm
3/6mm
9/12mm
15/18mm
1. Select the
cutting heights
indicated on the
insides and
sides of the
attachments.
2. Mount the
attachment to
the clipper as
illustrated.
3. To remove the
attachment
from the clipper
1 Natural cutting attachment
This attachment allows thinning of hair by cutting
from the inner side. Hair volume is reduced, and hair
tips are trimmed at various lengths to leave a natural
look. Desirable hair lengths for this attachment:
30 mm-70 mm (hair lengths shorter than 30 mm may
be too short to cut in some situations.)
1 Thinning Attachment
1. Insert the attachment
over the trimming blades
until it clicks as
illustrated.
2. To remove the
attachment, push both
sides while pulling the
attachment.
ER5209(EU).indb 3 2007/02/22 18:09:48