Panasonic VWBN1 - Manual (Page 14)

14
LSQT1269
∫ Connection and recognition
procedures
≥ Connect this unit to the AC adaptor.
1 Connect this unit to the PC.
≥ This unit is recognised as
a [DVD-RAM Drive] on
[My Computer].
≥ Insert the plugs as far as they will go.
The unit and PC will not operate
properly if they are not inserted fully.
≥ Be sure to use the USB cable
supplied with the video camera. (We
cannot guarantee operation if you
use a USB cable other than the one
supplied with the Panasonic video
camera.)
2 Start copying/playback.
≥ Use the software supplied with a
Panasonic video camera to copy/
play back the pictures.
≥ Read the operating instructions of
the software for information about
how to copy/play back.
∫ To disconnect the USB cable safely
If the USB cable is disconnected while the
access lamp is lit, this unit may malfunction
and the data may be lost.
1 Check that the access lamp is not lit.
2 Double click the ( ) icon in
task tray.
≥ Hardware disconnect dialogue
appears.
≥ Depending on your PC’s settings,
this icon may not be displayed.
3 Select [USB Mass Storage Device]
and click [Stop].
4 Click [OK].
≥ Click [OK], and you can safely
disconnect the cable.
¬ Cautions for Use
∫ About this unit
The unit and disc become warm after long
operation, but this is not a malfunction.
Keep the unit as far away as possible from
electromagnetic equipment (such as
microwave ovens, TVs, video games etc.).
≥ If you use the unit on top of or near a TV,
the pictures and sound on the unit may be
disrupted by electromagnetic wave
radiation.
≥ Do not use the unit near cell phones
because doing so may result in noise
adversely affecting the pictures and sound.
≥ Recorded data may be damaged, or
pictures may be distorted, by strong
magnetic fields created by speakers or large
motors.
≥ Electromagnetic wave radiation generated
by microprocessors may adversely affect
the unit, disturbing the pictures and sound.
≥ If this unit is adversely affected by
electromagnetic equipment and stops
functioning properly, disconnect the AC
adaptor and then connect it again.
Do not use the unit near radio
transmitters or high-voltage lines.
≥ If you record near radio transmitters or
high-voltage lines, the recorded pictures
and sound may be adversely affected.
Make sure to use the supplied cords
and cables.
Do not extend the cords and the cables.
Do not spray insecticides or volatile
chemicals onto the unit.
≥ If the unit is sprayed with such chemicals, its
body may be marred and the surface finish
may peel off.
≥ Do not leave rubber or plastic products in
contact with the unit for a long time.
Do not subject this unit to vibrations or
impacts, shake, drop or bump it, place
objects on top of it or drop objects on it.
≥ A strong impact can break the unit’s casing,
causing it to malfunction.
A
AUSB cable
(supplied with the video camera)
In particular, do not place a video camera
etc. on top of this unit during use. If this
unit is subjected to vibration during disc
reading or writing, the operation of the
video camera may be affected or the video
camera may fall.
LSQT1269.book 14 ページ ２００７年７月２３日 月曜日 午後４時２２分