Audio2000's AKJ7809 - Manual (Page 26)

23
Descriptions and Functions
Rear panel
2 3 4 5 9 1 7 8 6
1.FUSE TERMINAL - This terminal houses the AKJ7809 main system FUSE.
2.VOLTAGE SELECTOR - This selector toggles between 110-120V and 220-240V power settings. Please
make sure this toggle is set to the correct position, matching the receiving AC outlet's power supply before
plugging it in and operating it. Not doing so may cause severe damage to the unit and void your product warranty.
3.MAIN POWER switch- This switch can be set to ON or OFF position as follows:
●ON - to turn on the AKJ7809 power.
●OFF - to turn off the AKJ7809 power.
Note: The red POWER /STANDBY button on the front panel will not turn the AKJ7809 on if the MAIN POWER
switch is switched OFF.
4.EFFECTS INSERT jacks - The effects inserts allows you to add external effects to the audio signal without
compromising the original signal. Use the MIC IN/OUT when adding effects to the vocal signal ,use the
KEYBOARD IN/OUT when adding effects to the Music and use the GUITAR IN/OUT when adding effects
to the music.
5. 5.1 CHANNEL AUDIO OUTPUT jacks-These jacks are used for connecting to 5.1 channel ready
receivers/amplifiers. The label on each jack specifies which speaker in the surround sound system the
output signal from the labeled jack is sent to: FL-front left, FR-front right, SL-surround left, SR-surround
right, CEN-center, SW-subwoofer. The ML jack is the same as the FL jack and is used as the main left output
in a stereo system. The MR jack is the same as the FR jack and is used as the main right output in a stereo system.
6.COMPONENT VIDEO OUTPUT - These jacks output VIDEO to a TV monitor via COMPONENT VIDEO cables.
COMPONENT VIDEO outputs the different color signals (U/Pb and V/Pr) and luminance signal (Y) separately
for high-fidelity in reproducing colors. The description of the component video output connectors may differ
depending on the TV set or monitor i.e. Pr/Pb/Y or Cr/Cb/Y or R-Y/B-Y/Y. Component video cables only transmit
the video signal, separate cables are needed for audio signals. Please refer to the operating instructions of the
TV set or monitor for details.
7.COAXIAL OUTPUT - This digital output is for connecting devices with a COAXIAL cable.
8.VIDEO (RCA) and S-VIDEO OUT jacks - These jacks output video to a display device (TV, TFT, etc.). The
VIDEO jack outputs video using an RCA video cable. The S-VIDEO jack uses an S-VIDEO cable. S-VIDEO
provides better color separation and better resolution by separating the color and picture signals of a
composite-video signal.
9.OPTICAL OUTPUT - This digital out is for connecting devices with an OPTICAL cable. Please make sure to
remove the protective cover from this jack prior to connecting an OPTICAL cable. When not using this input,
keep the protective cover on to protect it from dust and foreign material.
2 3 0
PRE-OUT