Panasonic ERGS60 - Manual (Page 14)

14
English
4. Wipe off the water with a towel and
let it dry naturally.
• It will dry faster with the blade
removed.
5. Apply the oil to the blade after
drying. (See this page.)
6. Attach the comb attachment and
blade to the clipper.
Cleaning with the brush
1. Remove the clipper from the AC
adaptor.
• Make sure that the clipper is
turned off.
2. Remove the comb attachment.
3. Hold the main body, place your
thumb against the blades and then
push them away from the main body.
4. Brush off any hair trimmings from the
main body and from around the blade.
5. Brush any hair trimmings out from
between the stationary blade and
the moving blade while pressing
down the cleaning lever to raise the
moving blade.
6. Apply the oil to the blade.
7. Attach the comb attachment and blade to the clipper.
Lubrication
Apply the oil to the clipper before
and after each use.
Apply a drop of the oil to the
points indicated by the arrows.
Remounting the blade
Fit the mounting hook into the
blade mounting on the clipper
and then push in until you
hear a click.