Panasonic SCHC15EP - Manual (Page 6)

RQTX1246
6
E
N
G
L
IS
H
ENGL
ISH
6
Radio
Manual tuning
1 Press [RADIO, EXT-IN] to select “FM” or “AM”.
2 Press [3] or [5] to select the frequency of the required
station.
To tune automatically, press and hold the button until the frequency
starts changing quickly.
To improve the sound quality
When “FM” is selected
1 Press [RADIO MENU] to select “FM MODE”.
2 Press [Y, U] to select “MONO” and then press [OK].
To cancel, select “STEREO”.
• “MONO” is also cancelled when you change the frequency.
• Turn off “MONO” for normal listening.
When “AM” is selected
1 Press [RADIO MENU] to select “B.PROOF”.
2 Press [Y, U] to select “BP 1” or “BP 2” and then press [OK].
USB
You can connect and play MP3 tracks from your USB mass storage
device.
Do not use a USB extension cable. The system cannot recognise USB
mass storage device connected through a cable.
1 Decrease the volume and connect the USB mass storage
device to the USB port.
2 Press [USB] and then press [4/9] to start playback.
Stop playback Press [8] during playback.
“RESUME” is shown.
Press [4/9] to continue playback.
OR
Press [8] two times to stop the playback fully.
For other operations, refer to “Discs” (Z 5).
Compatible devices
• USB mass storage devices that support bulk-only transfer.
• USB mass storage devices that support USB 2.0 full speed.
Supported format
• Folders are defined as album.
• Files are defined as track.
• Track must have the extension “.mp3” or “.MP3”.
• CBI (Control/Bulk/Interrupt) is not supported.
• NTFS file system is not supported (only FAT 12/16/32 file system is
supported).
• Some files can fail to work because of the sector size.
Note:
• Maximum album: 255 albums (including root folder)
• Maximum track: 2500 tracks
• Maximum track in one album: 999 tracks
1 Press [PROGRAM] in the stop mode.
2 Press [R, T] to select the desired album.
3 Press [6] and then press the numeric buttons to select the
desired track.
4 Press [OK].
Do steps 2 through 4 again to program other tracks.
5 Press [4/9] to start playback.
Cancel
program mode Press [PROGRAM] in the stop mode.
Replay the
program Press [PROGRAM] and then press [4/9].
Check
program
contents Press [2] or [6] when “PGM” is shown in the
stop mode.
To check while programming, press [PROGRAM]
two times after “PGM” is shown, then press [2]
or [6].
Clear the last
track Press [DEL] in the stop mode.
Clear all
programmed
tracks Press [8] in the stop mode. “CLR ALL” is shown.
Within 5 seconds, press [8] again.
Note:
The program memory is cleared when you open the sliding door.
Viewing available information
You can view the available information on the display panel.
Press [DISPLAY].
Note:
• Maximum characters that can be shown: approximately 30
• This system supports ver. 1.0, 1.1 and 2.3 ID3 tags.
• Text data that the system does not support can show differently.
Note on CDs
• This system can access up to 99 tracks.
• This system can play MP3 files and CD-DA format audio CD-R/RW
that have been finalised.
• This system can fail to play some CD-R/RW because of the condition
of the recording.
Note on MP3s
• Files are treated as tracks and folders are treated as albums.
• This system can access up to 999 tracks, 255 albums (including root
folder) and 20 sessions.
• Disc must conform to ISO9660 level 1 or 2 (except for extended
formats).
• To play in a certain order, prefix the folder and file names with 3-digit
numbers in the order you want them to play.
Limitations on MP3 playback
• If you have recorded MP3s on the same disc as CD-DA, only the
format recorded in the first session can be played.
• Some MP3s cannot be played because of the condition of the disc or
recording.
• Recordings will not necessarily be played in the order you recorded
them.
SC-HC15_EP_01en.indd 6 SC-HC15_EP_01en.indd 6 3/11/2011 5:24:21 PM 3/11/2011 5:24:21 PM