Allied Telesis AR44xS series - Manual (Page 47)

Features in 276-02 47
Version 276-05
C613-10474-00 REV D
CR00012283 Switch 3 Previously, it was not possible to create two protocol-based VLANs on the same
ports if they had the same protocol but a different Ethernet encapsulation.
This issue has been resolved, so you can now create such VLANs.
- - - - - - - Y Y -
CR00012305 QoS 3 When a user entered a maxbandwidth for QoS, the switch sometimes displayed
a message that said the bandwidth units were “kbytes” instead of kilobits per
second.
This issue has been resolved.
- - - Y Y Y Y - - -
CR00012307 VLAN 3 Previously, when MSTP was configured it was not possible to delete ports from
VLANs in the MSTP CIST, unless MSTP was first disabled.
This issue has been resolved. Deleting such ports is now permitted.
- - - Y Y Y Y Y Y -
CR00012314 TACACS+,
Telnet
3 If a user connects to the router or switch via telnet and is authenticated using
TACACS+, previously the rem_addr field in the TACACS+ packets contained the
text “Telnet x” (where x was the number of the telnet session) instead of the
remote IP address.
This issue has been resolved. The rem_addr field now contains the remote IP
address.
Y Y Y Y Y Y Y Y Y Y
CR00012322 Classifier 3 If a user created a classifier that specified an IP address without specifying a
protocol (for example, create classifier=1 ipda=20.20.20.10/24), and saved
the configuration with the create config command, the resulting configuration
file included a value for protocol (for example, create class=1 prot="ip"
ipda=20.20.20.10/24). This prevented the router or switch from applying the
classifier to IPsec tunnelled traffic.
This issue has been resolved. The protocol value is no longer added to such
classifiers, which leaves them matching the default of any.
Y Y Y Y - - - - - -
CR Module Level Description AR44x
S /
AR4
50S
AR7x5 AR750
S
Rapi
er
i
A
T-
880
0
A
T-
860
0
A
T-
870
0XL
A
T-
894
8
A
T-
990
0
A
T-
980
0