Panasonic MCCG522 - Manual (Page 23)

23
Maintaining the pre-motor fi lter
Remove the dust bag. (see replacing the dust bag)
Remove pre-motor fi lter from its slot, wash gently with water and then allow
it to dry in shaded area.
Replace all parts to their original positions.
If the dust bag is not properly installed, the dust cover cannot be closed.
1. 2. 3.
1.
2.
3.
Specifi cations MC-CG524 MC-CG522
Power source 230 V ~ 50 Hz
Max input 1400 W 1300 W
Nominal input 1300 W 1250 W
Dimensions (W x L x H) 304 mm x 450 mm x 240 mm
Net weight 4.5 kg
Extension wands Telescopic
Floor nozzle √
Crevice nozzle √
Dusting brush √
Class with respect to protection against electric shock: *
Cleaning the outside of the appliance
Clean the outside of the appliance with a soft cloth.
Cleaning the fl oor nozzle
Use an old tooth brush or similar tool to clean any dirt or lint from the brush.
MC-CG524 MC-CG522
CAUTION
Do not wash the fl oor nozzle with water.
MAINTENANCE
TROUBLESHOOTING
Please check the following fi rst if you have any problems.
Problem Solution
The appliance does not switch on. Check if the plug is connected fi rmly and the socket outlet is working normally.
If a thermal cut-out device has activated, wait approximately 60 minutes until it has reset. −
−
The mains lead does not come out. Rewind and pull out the mains lead repeatedly while pressing the cord rewind pedal without using
excessive power. −
The mains lead does not fully rewind. Pull the mains lead out 2 m to 3 m and then press the cord rewind pedal to rewind the mains lead
while holding the plug. −
Suction power has decreased. Check if the dust bag is full.
Check for blockages in hose, telescopic wand, nozzles and pre-motor fi lter. Then clean those parts as
necessary. −
−
If the problem cannot be solved, please contact your local customer service centre. The contacts can be found in “GUARANTEE”, the separate paper which has
been attached with the appliance.
WARNING
Remove the plug from the socket outlet before cleaning or maintaining the
appliance.
CAUTION
Do not use detergent or any other cleaning liquids.
−
−
CAUTION
Attach the pre-motor fi lter correctly to avoid damaging motor.
Replacing the exhaust fi lter
Replace the exhaust fi lter once a year.
Detach two tabs of body cover from the rear side and replace the fi lter with a new one.
Put the body cover back to the main body.
Flat surface
face down
MC-CG522 MC-CG524
or
English