A&D Blood Pressure Monitor UA-787 - Manual (Page 8)

You must install 4 type AA (1.5 volt) batteries (alkaline batteries recommended),
or use the AC Adapter (see page E-14 for using the Monitor with AC Adapter)
and attach the cuff to the monitor before using it. To install batteries (or replace
them if the “Low Battery” symbol appears on display), proceed as follows:
1. Remove battery compartment cover by gently pushing down on arrow
and sliding cover forward.
2.
Put in bottom row of batteries first. Place the
batteries in compartment with positive (+) and
negative (–) terminals matching those indicat-
ed in the compartment. Be sure batteries make
contact with compartment terminals.
3.
Replace cover by sliding it into the compart-
ment and gently pressing into place.
NOTE: Rechargeable batteries will not work
with this monitor.
LifeSource ® blood pressure monitors are easy to use, accurate and digitally
display full measurement readouts. Our technology is based on the “oscillo-
metric method” – a noninvasive blood pressure determination. The term
“oscillation” refers to any measure of vibrations caused by the arterial pulse.
Our monitor examines the pulsatile pressure generated by the arterial wall as
it expands and contracts against the cuff with each heartbeat.
The cuff is inflated until the artery is fully blocked. The inflation speed is
maximized and the pressure level is optimized by the device. The monitor
takes measurements while the cuff is both inflating and deflating. This results
in a faster measurement providing greater comfort to the user.
Step 1
Step 2
Step 3
HOW UA-787 WORKS
?
BEFORE YOU START
LifeSource Health Line (Toll-Free): 1-888-726-9966 E-4
?!