Smart Technologies SMART Table 230i - Manual (Page 4)

C A U T I O N
l
Disconnect the power cable only after you turn off the table as documented in this guide and
the indicator lights and fans turn off. Disconnecting the power cable at any other time can
shorten the life of the projector lamp.
l
Do not place cords, boxes or other items on the surface of your table. Doing so can scratch
the surface.
l
Do not place heavy items on the surface of your table or expose it to heat. Doing so can
damage the surface.
l
If your SMART product becomes wet, dry it completely before turning it on.
l
SMART Technologies recommends that you use the remote control to complete only the
procedures documented in this guide. Using the remote control for other purposes may
change the projector’s settings, which were specifically configured for the table.
I M P O R T A N T
l
Do not operate your table’s projector in environments that are higher than 10,000' (3,000 m)
above sea level.
l
Your SMART Table is sensitive to infrared radiation and can interpret bright light as touches.
It could be necessary to turn off or remove any pot lights or other incandescent lighting in the
room and move your table away from bright windows, or close any open blinds or curtains
before using your table.
l
Your table’s surface does not respond to touch until the computer completes its startup
process. Wait 30 to 60 seconds after you turn on your table before you touch the surface.
l
Before you clean your table, turn it off so that you do not inadvertently start applications when
you wipe the surface.
l
Do not place keyboards, mouse devices or other objects on the touch surface. The camera
may interpret these objects as touches if they are placed on the touch surface.
l
This product contains lithium button cell batteries in the computer and in the remote
control (perchlorate material—special handling may apply).
I M P O R T A N T I N F O R M A T I O N
ii