Aviom AV-P2 - Manual (Page 14)

 
AV-P2 Rear Panel
The rear panel of the AV-P2 Output Module contains the DC power
connector, the left/right audio output Euroblock connections, and the
A-Net connections.
The outputs on the AV-P2 use 5.0 mm Euroblock connectors, and can
be connected to balanced or unbalanced audio devices. Male Euroblock
jacks are provided.
LEFT
DC
POWER
RIGHT OUT IN
AUDIO OUTPUT
AV-P2
+ – + –
18-24 VDC
500mA
The AV-P2 rear panel interface
Power Connector
The AV-P2 Output Module comes with an external DC switching-type
power supply. This type of power supply can be used worldwide with
a wide range of AC wall current output voltages (100-240VAC). When
traveling, you do not need to replace the power supply in countries
where voltages are different. You may, however, need plug adapters
to allow the power supply to be connected to wall outlets in some
countries, since many countries use different physical plug layouts for
their power systems.
If a replacement power supply is required, always choose a power supply
with equivalent specifications: 18-24 VDC, 500mA, center pin positive.
Audio Outputs
Audio outputs on the AV-P2 are provided via locking Euroblock
connectors. Each channel’s output level can be set individually using
the DIP switches on the front panel.
Euroblock connectors plug into the sockets on the AV-P2 panel.
The Euroblock plugs can be connected using only a small flat-blade
screwdriver.
A-Net Connections
Two A-Net connections are provided on the rear panel of the AV-P2
Output Module. There is one A-Net In port and one A-Net Out port.
The A-Net In port receives digital data in Aviom’s proprietary A-Net
format. The A-Net Out port is used to pass incoming A-Net data to
additional A-Net compatible devices in a system. The A-Net Out port
will always transmit the full 16-channel A-Net stream regardless of the
settings on the AV-P2.
LEFT
DC
POWER
RIGHT OUT IN
AUDIO OUTPUT
AV-P2
+ – + –
18-24 VDC
500mA
The AV-P2 rear-panel A-Net connections