Battery charger] charging, Main switch lock, Battery pack (ey9l10) – Panasonic EY7411 User Manual

Page 11: Li-ion battery pack (ey9l10), Battery pack life, Battery recycling, Common cautions for the li- ion/ni-cd battery pack

Advertising
background image

- 11 -

switch while the main switch is on

(switch is in the ON position).

Main Switch Lock

After use, set the main switch lock at

the lock position to prevent accidental

operation.

Main switch lock

Lock

Battery Pack (EY9L10)

1. Remove the battery pack away from

the tool.

. Charge the battery pack using the

battery charger.

3. After charging has been completed,

remove the battery pack from the

charger and connect it to the tool.

Disconnect the charger from the

power source when not in use.

NOTE:

Use under extremely hot or cold

conditions will reduce operating

capacity per charge.

[Battery Pack]

For Appropriate Use of Bat-

tery pack

Li-ion Battery pack (EY9L10)

• For optimum battery life, store the Li-

ion battery pack following use without

charging it.

• The ambient temperature range is

between 0°C (3°F) and 40°C (104°F).

If the battery pack is used when the

battery temperature is below 0°C

(3°F), the tool may fail to function

properly.

• When battery pack is not in use,

keep it away from other metal objects

like: paper clips, coins, keys, nails,

screws, or other small metal objects

that can make a connection from one

terminal to another.

Shorting the battery terminals togeth-

er may cause sparks, burns or a fire.

• When operating the battery pack,

make sure the work place is well ven-

tilated.

Battery Pack Life

The rechargeable batteries have

a limited life. If the operation time

becomes extremely short after

recharging, replace the battery pack

with a new one.

Battery Recycling

ATTENTION:

For environmental protection and

recycling of materials, be sure

that it is disposed of at an officially

assigned location, if there is one in

your country.

[Battery Charger]
Charging

Common Cautions for the Li-

ion/Ni-Cd Battery Pack

NOTE:

• When a cold battery (of about 0°C

or less) is to be charged in a warm

room, leave the battery in the room

for at least one hour and charge

it when it has warmed up to room

temperature. (Failing to do so may

result in less than a full charge.)

• Cool down the charger when charging

more than two battery packs consecu-

tively.

• Do not insert your fingers into con-

tact hole, when holding charger or

any other occasions.

CAUTION:

To prevent the risk of fire or damage

to the battery charger.

Advertising