Panasonic EY7411 - Manual (Page 9)

- 9 -
Operation Display No. of
seconds
Following the
screw count,
screw driving
within the set
number of
seconds is
not counted.
30 3
seconds
1 0.1
second
0 OFF
● If is pressed, the time setting
saved from the previous setting is
displayed.
3. The settings are activated by press-
ing .
4. To prevent changes in the set values
due to operational errors.
ON
● Turn the HOLD switch
to ON.
To change the screw count while in
use
1. Release the hold switch.
. Adjust the count value with .
● The displayed number of screws
to be driven can be changed within
the range of the screw count val-
ues.
3. To prevent changes in the set values
due to operational errors.
ON
● Turn the HOLD switch
to ON.
■ While setting, if no operations are
conducted for 60 or more seconds
and when the battery is removed
● Operation for the set value be-
comes invalid.
Please reset the operational
values.
■ When batteries are changed while in
use
● When batteries are changed, the
count value is saved. Therefore,
the drill can be used continuously.
 Battery Low Warning Lamp
<Battery low warning lamp>
Off
(normal
operation)
Flashing
(No charge)
Battery
protection
feature active
Excessive (complete) discharging of
Li-ion batteries shortens their service
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
● The battery protection feature acti-
vates immediately before the bat-
tery loses its charge, causing the
battery low warning lamp to flash.
● If you notice the battery low warn-
ing lamp flashing, charge the bat-
tery pack immediately.
 Clutch Lock Cover
The clutch lock cover allows you to
lock the clutch at the selected setting.
Attaching the cover
1. Select the appropriate clutch set-
ting for the application.
. Attach the clutch lock cover.
● Align the triangle mark on the
cover with the graduation selec-
tion mark on the drill and attach.
Triangle mark Graduation selection
mark
Removing the cover
1. Grip the clutch lock cover with your
fingers on the  mark and the bot-
tom of the cover, then push in and
twist to remove.