Panasonic HC-V130K - Manual (Page 95)

- 95 -
When the status indicator is flashing at a
particularly fast or slow rate, the following
should be considered.
Flashing with approx. 4 second period (off
for approx. 2 seconds, on for approx. 2
seconds):
≥ When the battery is over discharged or the
temperature of the battery is too high or low.
It can be charged, but it may take a few hours
to complete the charging normally.
≥ It will flash in approx. 2 second intervals
when normal charging resumes. Even in such
cases, it may start flashing in approx.
4 second intervals until charging is completed
depending on the conditions of use.
Flashing with approx. 0.5 second period (off
for approx. 0.25 second, on for approx. 0.25
second):
≥ The battery is not charged. Remove the
battery from the unit, and try charging again.
≥ Check that the terminals of the unit or battery
are not dirty or covered with a foreign object,
and connect the battery correctly once again.
If a foreign object or dirt is present, turn off
the unit before removing.
≥ The battery or environment is at an extremely
high or low temperature. Wait until the
temperature has returned to an appropriate
level and try charging again. If you are still
unable to charge, there may be a fault in the
unit, battery or AC adaptor.
Off:
≥ Charging has finished.
≥ If the status indicator stays off despite the
charging being unfinished, there may be a
fault in the unit, battery or AC adaptor. Refer
to page
94 for details on the battery.
When disposing of or giving away the SD
card, note that:
≥ Formatting and deletion of this unit or
computer only changes the file management
information and does not completely delete
the data in the SD card.
≥ It is recommended that the SD card is
physically destroyed or the SD card is
physically formatted using this unit when
disposing of or giving away the SD card.
For the physical format, connect the unit to
the AC adaptor, select [SETUP]
# [FORMAT
MEDIA] # [YES] from the menus, and then
press and hold down the Recording start/stop
button for approximately 3 seconds on the
screen below. When the SD card data
deletion screen appears, select [YES], and
then follow the on-screen instructions.
≥ When the LCD screen is dirty or
condensation has occurred, please wipe it
using a soft cloth such as eyeglass cleaner.
≥ When the unit has become very cold, for
example due to storage in a cold area, its
LCD monitor will be slightly darker than usual
immediately after the unit is turned on. The
normal brightness will be restored when the
unit’s internal temperature rises.
About status indicator during
charging About the SD card
LCD monitor
Extremely high precision technology is
employed to produce the LCD Monitor
screen. The result is more than 99.99%
effective dots with a mere 0.01% of the dots
inactive or always lit. However, this is not a
malfunction and does not affect the recorded
picture.