ACTiSYS ACT-IR4000US - Manual (Page 18)

© Copyright 2002-2008 ACTiSYS Corp. Page 18 of 21 Jul 8, 2008
Version 1.6.0.1
The Wireless Connectivity Expert
ACT-IR4000US Series
User’s Manual
10. TROUBLE SHOOTING
In order to help on general and miscellaneous problems you may be experiencing with, refer to the
following pages for possible solutions. Look up your problem and try the solution.
SYMPTOM PROBLEM Solution
Can not establish link
(General)
1. The two IR devices are not
aligned properly.
2. Distance is too near or far.
3. Device is inactivated
4. BIOS setting incorrect
5. Installation is not correct.
1. Properly align them again
2. Move one device to a
proper distance.
3. Enable the device by IR
monitor.
4. Correct the BIOS Setting.
5. Refer to un-installation
guide to remove the
device, then install again.
File Transfer between
IR-equipped PDA and
ACT-IR device-attached host
computer stops before
finishing up and an error
message appears.
The infrared communication
is interfered. For example,
something blocks out the
infrared beam or the burst of
string light source, etc.
Check to find out the source
of interference and eliminate
it before trying again.
The device work well before.
But after I unplug it then
plug, it does not work again.
Improper unplug and plug
procedure
Before you unplug it, you
should disable the device.
And enable the device after
you plug it into your
computer