Panasonic DMC-GH4KBODY - Manual (Page 113)

113
4. Focus and Shutter (Drive Mode) Settings
Taking Pictures using Burst Mode
Pictures are taken continuously while the shutter button is pressed.
•
Pictures taken with a burst speed of [SH] will be recorded as a single burst group (P225) .
1
Set the drive mode dial to [ ].
2
Focus on the subject and take a picture.
• Hold down the shutter button fully to activate the Burst
Mode.
∫ Changing the burst speed
1
Select the menu. (P54)
2 Press 3/4 to select the burst speed and then press [MENU/SET].
Applicable modes:
> [Rec] > [Burst Rate]
[SH] ¢2
(Super high
speed)
[H]
(High
speed)
[M]
(Middle
speed)
[L]
(Low speed)
Burst speed
(pictures/second)
40
12 (AFS)
7 (AFC)
7 2
Live View during Burst Mode None None Available Available
¢1
With RAW files — 40 ¢3, 4, 5
Without RAW
files
Max. 120 100 or more ¢3, 4, 5
¢1 Number of burst shots
¢2 The electronic shutter will operate.
¢3 Recording conditions are based on CIPA standards and an SDHC card manufactured
by Panasonic is used.
¢4 Depending on the recording conditions, the number of frames in a burst may be
reduced. (For example, when you set [i.Resolution] of the recording menu, the number
of frames in a burst may be reduced)
¢5 Pictures can be taken until the capacity of the card becomes full. However the burst
speed will become slower halfway. The exact timing of this depends on the aspect
ratio, the picture size, the setting for the quality and the type of card used.
AFS AFS
FHD
MOV
24 p L
4:3
H
MENU