Panasonic EY7549X - Manual (Page 8)

- 8 -
24) NOTE: If the supply cord of this ap-
pliance is damaged, it must only be
replaced by a repair shop authorized
by the manufacturer, because spe-
cial purpose tools are required.
25) TO REDUCE THE RISK OF ELEC-
TRIC SHOCK, THIS APPLIANCE
HAS A POLARIZED PLUG (ONE
BLADE IS WIDER THAN THE
OTHER).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
WARNING!
• Do not use other than the Panasonic
battery packs that are designed for use
with this rechargeable tool.
• Panasonic is not responsible for any
damage or accident caused by the use
of the recycled battery pack and the
counterfeit battery pack.
• Do not dispose of the battery pack in a
fire, or expose it to excessive heat.
• Do not drive the likes of nails into the bat-
tery pack, subject it to shocks, dismantle
it, or attempt to modify it.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack
in the same container as nails or similar
metal objects.
• Do not charge the battery pack in a hight-
emperature location, such as next to a fire
or in direct sunlight. Otherwise, the battery
may overheat, catch fire, or explode.
• Never use other than the dedicated char-
ger to charge the battery pack. Otherwise,
the battery may leak, overheat, or
explode.
• After removing the battery pack from the
tool or the charger, always reattach the
pack cover. Otherwise, the battery contacts
could be shorted, leading to a risk of fire.
• When the Battery Pack Has Deteriorated,
Replace It with a New One.
Continued use of a damaged battery pack
may result in heat generation, ignition or
battery rupture.
IV. ASSEMBLY
Using Keyless drill chuck
(EY9X003E)
CAUTION: • Use keyless drill chuck ONLY
in Drill Driver Mode.
This chuck is not designed to
be used in IMPACT MODE.
It can be damaged and its life
will be reduced. Moreover,
the chuck and its metal parts,
such as the push button, front
parts, and bit may become
very hot. To prevent skin
burns, use work gloves and/
or allow heated parts to cool
down before handling.
• Make sure the work envi-
ronment is safe. When
retracting drill from work
material, Keyless drill chuck
may detach if subjected to
100 kg or more of pull force.
Detachment will be sudden.
Use care and avoid excessive
force when retracting drill from
work material.
1. Attaching Keyless drill chuck
Attach the chuck by sliding the female
detent on the bottom of the chuck to
the square drive on the body.
Make sure the chuck is firmly connect-
ed to the body.
2. Inserting the bit
Insert the bit, and turn the lock collar
clockwise (looking from the front) hold-
ing the sleeve until jaws close firmly.
①
②
EY7549.indb 8 EY7549.indb 8 2013-10-17 18:34:46 2013-10-17 18:34:46