Panasonic TYTP42P8S - Manual (Page 10)

10
USB
Pen
OFF ON
Connection between the computer and plasma display
Connection with computer
∗ Check that the USB power supply of the computer being used is rated at 500 mA.
(1) Connect the plasma display and computer with the VGA cable.
(2) Turn on power in the following sequence: 1: Plasma Display, 2: Computer.
(3) Switch the plasma display input signal to the computer.
(4) After the computer OS starts up, connect the touch panel and computer with the USB cable.
(5) Insert the CD-ROM containing the USB driver into the CD drive of the computer, start the install wizard, and install
the USB driver software by following the instructions on the screen.
Notes:
• After the computer OS has finished starting up, connect the USB cable.
• If you connect using a USB hub, you must supply power to the USB hub.
• For details on USB driver software setup, see “USB driver setup.” (See below)
• After USB driver setup, you must set up the touch panel driver software. (See page 21)
• If the infrared transmissive part of the screen is accidentally obstructed (such as by your finger) while connecting the
USB, an element defect will be detected. If you use the system in that state, it may respond poorly to touch. If this
happens, remove the USB cable and insert it again. You do not need to restart the computer.
USB cable
Installation of the USB driver
In case of Windows 98 Second Edition (SE) ............ page 12
In case of Windows Millennium Edition (ME) ............ page 14
In case of Windows 2000 .......................................... page 16
In case of Windows XP ............................................. page 18
Plasma Display (Rear view)
Touch Panel
Computer
USB connector
1
In order to prevent the USB cable from being pulled out, use the
following procedure to attach the fixing bracket.
2
1 Fix the USB cable fixing bracket onto the USB
cable.
2 Line up the fixing bracket screw hole with the
hole on the touch panel.
3 Fix the bracket in place using the two fixing
screws.
USB
Pen
OFF ON
1
2
3
Mounting screws
for USB cable
(accessory)
Mounting
bracket for
USB cable
(accessory)
USB cable
(accessory)