AT&T Plug&Share 6800G - Manual (Page 6)

Getting Started
AT&T Plug&Share ™ 54 Mbps Wireless Router 6800G 6
Router Controls, Connections and Indicator Lights
LAN Ports 1- 4
RJ45 jacks for cable con-
nections to a local area
network. After installation
and setup, you will not
need cabling to wirelessly
share resources throughout
the network.
WAN Port
This port provides Internet
access when connected to
a DSL or cable modem.
(“WAN” stands for “Wide
Area Network.”)
Power
Plug in your power adapter
here, then plug it into an
electrical outlet.
Reset button
Make sure the router is plugged in and turned on, then
press and hold this button for 15 seconds to restore
factory programmed default settings. You will have to
run the Setup Wizard again if you use this feature
(see page 8).
Power
A steady light indicates that the
router is properly connected to
the power supply.
Wireless LAN
A steady light indicates that the
wireless connection is working
properly. The light blinks during
data transfer.
WAN
A steady light indicates the
router is properly connected to
your modem. The light blinks
during data transfer.
LAN1- LAN 4
A steady light indicates that
there is a connection to an
Ethernet-enabled computer on
one of the ports. The light blinks
during data transfer.
BACK FRONT