American Megatrends III - Manual (Page 49)

Chapter 2 WINBIOS Setup 45
Advanced Setup, Continued
Boot Up Num Lock Set this option to On to turn the Num Lock key On at system boot. The
settings are On or Off. The Optimal and Fail-Safe default settings are On.
Password Check This option enables the password check option every time the system boots or
the end user runs Setup. If Always is chosen, a user password prompt appears
every time the computer is turned on. If Setup is chosen, the password prompt
appears if WINBIOS is executed. The Optimal and Power-On defaults are
Setup.
Boot To OS/2 Set this option to Yes if running OS/2 operating system and using more than
64 MB of system memory on the motherboard. The settings are Yes or No.
The Optimal and Fail-Safe default settings are No.
Floppy Drive Swap Set this option to Enabled to permit drives A: and B: to be swapped. The
settings are Enabled or Disabled. The Optimal and Fail-Safe default settings
are Disabled.
Boot Up Sequence This option sets the sequence of boot drives (either floppy drive A, hard
disk drive C:, or a CD-ROM drive.) AMIBIOS attempts to boot from after
AMIBIOS POST completes. The three settings are C:,A:,CDROM,
A:,C:CDROM, and CDROM,C:,A:. The Optimal default setting is
C:,A:CDROM. The Fail-Safe default setting is A:,C:CDROM.
Cont’d