For further information contact ups direct ltd – American Power Conversion APC Smart-UPS 750VA User Manual

Page 13

Advertising
background image

For further information contact UPS Direct Ltd:

Tel: 08456 445 002 - Fax: 08456 445 003 - Email: [email protected] - Website: www.upsdirect.com

11

5: T

ROUBLESHOOTING

Use the chart below to solve minor Smart-UPS installation and operation problems. Refer to the APC

web site, www.apc.com, for assistance with complex UPS problems.

P

ROBLEM AND

P

OSSIBLE

C

AUSE

S

OLUTION

UPS

WILL NOT TURN ON

Battery not connected prop-

erly.

Check that the battery connector is fully engaged.

button not pushed.

Press the

button once to power the UPS and the connected equipment.

UPS not connected to utility

power supply.

Check that the power cable from the UPS to the utility power supply is se-

curely connected at both ends.

Very low or no utility voltage. Check the utility power supply to the UPS by plugging in a table lamp. If the

light is very dim, have the utility voltage checked.

UPS

WILL NOT TURN OFF

button not pushed.

Press the

button once to turn the UPS off.

Internal UPS fault.

Do not attempt to use the UPS. Unplug the UPS and have it serviced imme-

diately.

UPS

BEEPS OCCASIONALLY

Normal UPS operation when

running on battery.

None. The UPS is protecting the connected equipment.

UPS

DOES NOT PROVIDE EXPECTED BACKUP TIME

The UPS battery is weak due

to a recent outage or is near

the end of its service life.

Charge the battery. Batteries require recharging after extended outages.

They wear faster when put into service often or when operated at elevated

temperatures. If the battery is near the end of its service life, consider replac-

ing the battery even if the replace battery LED is not yet lit.

A

LL

LED

S ARE LIT AND THE

UPS

EMITS A CONSTANT BEEPING

Internal UPS fault.

Do not attempt to use the UPS. Turn the UPS off and have it serviced imme-

diately.

F

RONT PANEL

LED

S FLASH SEQUENTIALLY

The UPS has been shut down

remotely through software or

an optional accessory card.

None. The UPS will restart automatically when utility power returns.

A

LL

LED

S ARE OFF AND THE

UPS

IS PLUGGED INTO A WALL OUTLET

The UPS is shut down and the

battery is discharged from an

extended outage.

None. The UPS will return to normal operation when the power is restored

and the battery has a sufficient charge.

Advertising
This manual is related to the following products: