Aastra Telecom ATP-CNX-020 - Manual (Page 19)

Procedures
ATP-CNX-020 Rel. 1.2, Doc. Rev. 01.06 5
Aastra CNX Installation and Setup Procedures
Connecting the network cables
T1/E1 Connect the RJ-48C T1/E1 cable(s) to the RJ-48C T1/E1 port(s) on the rear panel of the
Aastra CNX .
Ethernet Connect the RJ-45 Ethernet UTP cable(s) to the RJ-45 10/100 ENET port(s) on
the rear panel of the Aastra CNX.
Make sure you have the network cables that you need for your facility, and connect them to the
following interfaces as appropriate:
Connect network cables 4
Ethernet RJ-45
connectors
T1/E1 RJ-48C
connectors
CONSOLE
10/100 ENET
RESET
T1 / E1
1 2 4 3 2 1
100-240VAC
1.0A 47-63HZ