Aastra Telecom ATP-CNX-020 User Manual
Page 23
Procedures
ATP-CNX-020 Rel. 1.2, Doc. Rev. 01.06
9
Aastra CNX Installation and Setup Procedures
(1) Run network and time configuration
Use the following procedure to initially configure the network settings on the Aastra CNX
hardware.
Step Action
1
After first-time power up of the CNX, the following displays in a terminal window:
Welcome to the
Aastra CNX - Conference Bridge
Configuration Utility
- please press <enter> to continue -
2
Press <Enter>.
The following displays:
Hostname:
3
Enter the hostname for the Aastra CNX and press <Enter>. For example:
Hostname: cnx1 ↵
The following displays:
Configuring ENET #1...
IP Address:
4
Enter the IP address for the Ethernet port for which you want to use as a management interface, and
press <Enter>. For example:
IP Address: 192.168.2.6 ↵
The following displays:
Netmask:
5
Enter the Netmask for the Ethernet port for which you want to use as a management interface, and
press <Enter>. For example:
Netmask: 255.255.255.0 ↵
The following displays:
Default Gateway:
(continued)