AMX PTM-D15 - Manual (Page 19)

Configuration and Setup
13 PTM-D15 15" Platinum Touch Panel
Configuration and Setup
This section covers the steps needed to configure the PTM-D15 panel communication features for
communication to a sample TPI/3 Interface using either Axcess or NetLinx.
PTM-D15 Startup and Setup Procedures
Now that the Platinum Touch Panel is powered and connected to the AXB-TPI/3 Touch Panel
Interface, all that’s left to do is to get the display settings adjusted and prepare it for displaying the
incoming signals from the TPI/3.
Rear Panel buttons
On the middle-right side of the touch panel is located a set of buttons that allow the user to activate
the panel and access panel display menus (FIG. 10). Refer to the Specifications section on page 2
for more information on the rear panel buttons.
1. Press the Power button on the panel to turn on the monitor. If no image appears on your
monitor, refer to the Troubleshooting section on page 33.
2. Adjust the resolution of the video signal from the video source.
The following sections require that you first use the TPI/3 with a Terminal Emulator (i.e., AxcessX
or Windows HyperTerminal).
FIG. 10 Rear panel buttons
Decrease button
Down button
Up button
Increase button
Power button
PTM-D15 Platinum
Touch Panel (rear view)
Menu Select button
On-Screen Display
Menu buttons
For best picture quality when using the panel to display an incoming computer signal,
adjust the video signal resolution from the computer to 1024 x 768 at 60 Hz.